全自動攪拌車多使用在工程建築中，為kaiyun的現代化建設作出了重大貢獻，攪拌車屬於專用車的一種，很多的攪拌車都出自“專汽之都”湖北隨州，它是由專用車底盤和上裝組成的，雖然是專用車，但是它跟其它車輛一樣也會偶爾出現故障，那麽攪拌車一般會出現哪些故障呢？
Fully automatic mixer trucks are commonly used in engineering and construction, making significant contributions to our modernization construction. Mixers are a type of specialized vehicle, and many of them come from Suizhou, Hubei, the "capital of specialized automobiless". They are composed of a specialized vehicle chassis and upper body. Although they are specialized vehicles, they also occasionally malfunction like other vehicles. So what are the common faults of mixer trucks?
對於全自動攪拌車出現的故障，kaiyun首先必須要了解故障出現的性質，結合攪拌車的車齡，這個故障是持續很長時間了還是突然出現的；空車和重載時故障是否依然存在；轉速不同時故障有沒有差別，以上這些因素都是要考慮的。
For the malfunction of a fully automatic mixer truck, we must first understand the nature of the malfunction, and based on the age of the mixer truck, whether the malfunction has persisted for a long time or suddenly appeared; Whether the fault still exists when the vehicle is empty or overloaded; Whether there are differences in faults when the speed is different, all of these factors need to be considered.
要知道攪拌車的罐體重心是在軸線上，正常狀態下罐體的運行是平穩的，但是如果積料或者運轉不均勻，就會導致罐體重心偏移，罐體在運行中就會出現抖動，那麽積料造成的抖動故障表現在以下兩個方麵：
It should be noted that the center of gravity of the tank body of the mixer truck is on the axis, and under normal conditions, the operation of the tank body is stable. However, if there is material accumulation or uneven operation, it will cause the center of gravity of the tank body to shift, and the tank body will shake during operation. The shaking fault caused by material accumulation is manifested in the following two aspects:
1.罐體抖動呈現周期性變化，2.罐體轉動抖動沒有規律，此時檢查油箱油液是否渾濁，減速機是否有損壞導致油液混入金屬顆粒。
1. The shaking of the tank body shows periodic changes, and 2. The shaking of the tank body is irregular. At this time, check whether the oil in the tank is turbid, and whether there is damage to the gearbox that has caused the oil to mix with metal particles.
故障具體分析：
Specific fault analysis:
液壓係統本身在輸出功率時是有聲音的，尤其是在大功率輸出時，所以如果空車就有大功率輸出的規律性噪音時，應排除是罐體積料方麵的原因，在重載時，如果負載過大超出係統溢流閥的設定值，係統就會溢流，此時液壓係統就會產生急劇的嘯叫聲，同時油溫會快速升高，一般機械原因的噪音會隨著發動機的轉速提高而產生。
The hydraulic system itself produces sound when outputting power, especially during high-power output. Therefore, if there is regular noise from high-power output when the vehicle is empty, it should be ruled out that it is due to the accumulation of material in the tank body. During heavy loads, if the load exceeds the set value of the system overflow valve, the system will overflow, and at this time, the hydraulic system will produce a sharp howling sound, while the oil temperature will quickly rise, Generally, mechanical noise can occur as the engine speed increases.
如果攪拌車出現重載時無力的情況，此時應拆開濾芯檢查，如果在濾芯內發現金屬粉末、銅沫甚至大塊金屬物，即可斷定是液壓泵或馬達磨損。
If the mixer truck becomes weak during heavy loading, the filter element should be disassembled for inspection. If metal powder, copper foam, or even large metal objects are found inside the filter element, it can be concluded that the hydraulic pump or motor is worn.
其實很多的攪拌車故障在駕駛室內部的儀表盤上也是可以看出來的，大家隻要在平時多加注意，及早的發現故障並處理，就不會因故障而耽誤攪拌車作業。您有需求就來kaiyun網站http://www.skar-bnat.com谘詢吧！
In fact, many mixer truck faults can also be seen on the dashboard inside the driver's cab. As long as everyone pays more attention in daily life, discovers and handles faults early, they will not delay the mixer truck operation due to faults. Come to our website if you have any needs http://www.skar-bnat.com Consult!
