Before starting the mixer track, the operating handle of the mixer drum must be in the "stop" position.
攪拌車啟動發動機後，應將攪拌鼓以低速旋轉約10分鍾，以便液壓油溫度在開始運行之前超過20°C。
After the mixer starts the engine, rotate the drum at a low speed for about 10 minutes so that the hydraulic oil temperature exceeds 20 ° C before starting operation.
如果攪拌車停在室外，則在裝載前應顛倒攪拌桶，以排出水和碎屑，以確保混凝土質量。
If the mixer truck is parked outside, the mixing drum should be reversed before loading to drain water and debris to ensure the quality of concrete.
在攪拌車運輸混凝土時，請確保滑動鏟鬥就位，以避免鬆動，行人受傷或搖擺，這可能會影響其他車輛的正常運行。至
When transporting concrete by mixer truck, please ensure that the sliding bucket is in place to avoid loosening, pedestrian injury or swing, which may affect the normal operation of other vehicles. to
當攪拌車裝載混合混凝土時，攪拌桶的速度為2-10 rpm。在運輸過程中，在平坦路麵上攪拌桶的速度保證為2-3 rpm。在超過50的側坡上行駛和在左右搖擺較大的道路上行駛時，必須在路麵狀況得到改善後停止混合料灌漿並重新開始混合料灌漿。
When the mixer truck is loading the mixed concrete, the speed of the mixing drum is 2-10 rpm. During transportation, the speed of the mixing drum is guaranteed to be 2-3 rpm on the flat road. When driving on the side slope over 50 and on the road with large left-right swing, the mixture grouting must be stopped and restarted after the road condition is improved.
混凝土攪拌車運輸混凝土的時間不得超過攪拌站規定的時間。在運輸混凝土期間，請勿長時間停止攪拌桶，以防止混凝土偏析。
The time of transporting concrete by concrete mixer truck shall not exceed the time specified by mixing station. During the transportation of concrete, do not stop the mixing bucket for a long time to prevent concrete segregation.
如果攪拌車裝有混凝土，則現場停滯時間不應超過一小時。如果時間已過去，現場人員將需要及時采取行動。
If the mixer truck is equipped with concrete, the dead time on site shall not exceed one hour. If time has passed, field personnel will need to take timely action.
攪拌車運輸的混凝土塊必須至少8厘米。從混凝土進入儲罐開始直至排出為止，在炎熱天氣下排出不應超過2小時，在寒冷天氣下排出不應超過2.5小時。
Concrete blocks transported by mixer truck must be at least 8 cm. From the beginning of concrete entering the storage tank to discharging, the discharging time shall not exceed 2 hours in hot weather and 2.5 hours in cold weather.
在攪拌車彈出混凝土之前，以10-12 rpm的速度旋轉攪拌桶1分鍾，然後彈出。
Before the concrete is ejected by the mixer truck, rotate the mixing drum at a speed of 10-12 rpm for 1 minute, and then eject.
混凝土攪拌機排幹車後，立即使用卡車附帶的軟管衝洗入口，排水漏鬥和排水槽，以排出車身上的灰塵或殘留混凝土。將150-200L的清水倒入攪拌桶中。在返回的過程中，緩慢旋轉攪拌桶以清潔內壁，防止爐渣粘附在攪拌桶壁和攪拌葉片上，加水並重新填充。
After the concrete mixer drains the truck, immediately flush the inlet, drain funnel and drain trough with the hose attached to the truck to remove dust or residual concrete from the truck body. Pour 150-200l clean water into the mixing bucket. In the process of returning, slowly rotate the mixing drum to clean the inner wall, prevent slag from adhering to the mixing drum wall and mixing blades, add water and refill.
