您好,歡迎光臨萊州kaiyun機械有限公司官方網站!

服務熱線

400-879-1999

你所在位置: 首頁 >> kaiyun > 常見問題 >
常見問題

自上料攪拌車在出車前需要注意哪些問題?

來源:http://www.skar-bnat.com/ 時間:2020-08-11

1、細心檢查及時發現排除故障。
1. Check carefully, find and remove the fault in time.
千萬不能讓自動上料攪拌車壞在路上,否則出現悶罐就麻煩了,混凝土一般停罐不能超過2個小時,C40往上級別的混凝土基本就不能停。點火之前先檢查機油、防凍液、潤滑油和冷卻水等,發現不足時,應重新進行添加。車子啟動後,再讓罐子低速旋轉,圍繞著車檢查輪胎氣壓,是否有漏氣的胎,再用螺絲刀剔掉在胎縫裏的石子,檢查是否有鐵釘之類紮在胎裏!
Do not let the automatic feeding mixer truck break down on the road, otherwise it will be troublesome for the tank to be blocked. Generally, the concrete can not be stopped for more than 2 hours, and the concrete with C40 grade can not be stopped basically. Before ignition, check the engine oil, antifreeze, lubricating oil and cooling water, and add them again if they are insufficient. After the car starts, let the jar rotate at a low speed. Check the tire pressure around the car to see if there is a leaking tire. Then use a screwdriver to remove the stones in the tire seams and check whether there are iron nails stuck in the tire!
再檢查燈光,尤其是腰燈,務必保證照著輪胎邊緣,工地會經常亂堆放鋼筋之類的東西,而胎側是最薄弱的。用抹布擦幹淨兩邊的後視鏡,窗戶玻璃,工地路況複雜,光線不好,視線一定要首先保證!
小型混凝土攪拌車
Check the light again, especially the waist lamp, and make sure to shine on the edge of the tire. The construction site will often pile up reinforcement and other things, and the sidewall is the weakest. Clean the rear-view mirror and window glass on both sides with dishcloth. The road conditions on the construction site are complex and the light is not good. The line of sight must be guaranteed first!
2、保證水箱裏有足夠的水,有減水劑,因各種原因料太幹,沒有水添加放不出料的時候,減水劑就是救命稻草了。
2. To ensure that there is enough water in the water tank, there are water reducing agents. Because of various reasons, the material is too dry. When there is no water to add and discharge, the water reducing agent is a lifesaving straw.
3、確認攪拌罐處於停止狀態,因為發動機啟動時萬一罐子處於高速旋轉狀態,瞬間的力會很大的,傷減速機。
3. Make sure that the mixing tank is in the stop state, because if the tank is in high-speed rotation state when the engine is started, the instantaneous force will be very large and damage the reducer.
4、無論是將手柄從攪拌到排放還是從排放到攪拌,都應使其停止在停止位置,然後撥到下一個操作位置。
4. Whether it is from mixing to discharging or from discharging to mixing, the handle should be stopped at the stop position and then moved to the next operation position.
感謝您的閱讀,此文的文章來源:小型混凝土攪拌車更多的內容和問題請點擊:http://www.skar-bnat.comkaiyun會繼續努力的為您提供服務,感謝您的支持!
Thank you for reading. This article is from small concrete mixer truck. For more information and questions, please click: http://www.skar-bnat.com We will continue to work hard to provide services for you, thank you for your support!
上一篇:小型混凝土攪拌車驅動刹車係統的維護保養
下一篇:混凝土攪拌車出廠前需要檢查哪些才算符合標準
tag:混凝土攪拌車,小型混凝土攪拌車,全自動混凝土攪拌車
當前位置: 首頁 - kaiyun > 常見問題 >

自上料攪拌車在出車前需要注意哪些問題?

作者:中科kaiyun混凝土攪拌車廠家 時間:2020-08-11

1、細心檢查及時發現排除故障。
1. Check carefully, find and remove the fault in time.
千萬不能讓自動上料攪拌車壞在路上,否則出現悶罐就麻煩了,混凝土一般停罐不能超過2個小時,C40往上級別的混凝土基本就不能停。點火之前先檢查機油、防凍液、潤滑油和冷卻水等,發現不足時,應重新進行添加。車子啟動後,再讓罐子低速旋轉,圍繞著車檢查輪胎氣壓,是否有漏氣的胎,再用螺絲刀剔掉在胎縫裏的石子,檢查是否有鐵釘之類紮在胎裏!
Do not let the automatic feeding mixer truck break down on the road, otherwise it will be troublesome for the tank to be blocked. Generally, the concrete can not be stopped for more than 2 hours, and the concrete with C40 grade can not be stopped basically. Before ignition, check the engine oil, antifreeze, lubricating oil and cooling water, and add them again if they are insufficient. After the car starts, let the jar rotate at a low speed. Check the tire pressure around the car to see if there is a leaking tire. Then use a screwdriver to remove the stones in the tire seams and check whether there are iron nails stuck in the tire!
再檢查燈光,尤其是腰燈,務必保證照著輪胎邊緣,工地會經常亂堆放鋼筋之類的東西,而胎側是最薄弱的。用抹布擦幹淨兩邊的後視鏡,窗戶玻璃,工地路況複雜,光線不好,視線一定要首先保證!
小型混凝土攪拌車
Check the light again, especially the waist lamp, and make sure to shine on the edge of the tire. The construction site will often pile up reinforcement and other things, and the sidewall is the weakest. Clean the rear-view mirror and window glass on both sides with dishcloth. The road conditions on the construction site are complex and the light is not good. The line of sight must be guaranteed first!
2、保證水箱裏有足夠的水,有減水劑,因各種原因料太幹,沒有水添加放不出料的時候,減水劑就是救命稻草了。
2. To ensure that there is enough water in the water tank, there are water reducing agents. Because of various reasons, the material is too dry. When there is no water to add and discharge, the water reducing agent is a lifesaving straw.
3、確認攪拌罐處於停止狀態,因為發動機啟動時萬一罐子處於高速旋轉狀態,瞬間的力會很大的,傷減速機。
3. Make sure that the mixing tank is in the stop state, because if the tank is in high-speed rotation state when the engine is started, the instantaneous force will be very large and damage the reducer.
4、無論是將手柄從攪拌到排放還是從排放到攪拌,都應使其停止在停止位置,然後撥到下一個操作位置。
4. Whether it is from mixing to discharging or from discharging to mixing, the handle should be stopped at the stop position and then moved to the next operation position.
感謝您的閱讀,此文的文章來源:小型混凝土攪拌車更多的內容和問題請點擊:http://www.skar-bnat.comkaiyun會繼續努力的為您提供服務,感謝您的支持!
Thank you for reading. This article is from small concrete mixer truck. For more information and questions, please click: http://www.skar-bnat.com We will continue to work hard to provide services for you, thank you for your support!

截屏,微信識別二維碼