1. Bring water reducing agent with the car: water reducing agent is a kind of concrete additive that can reduce the amount of mixing water under the condition of maintaining the same slump of concrete. It can be carried with the car and adjust the concrete well.
2、回廠檢查罐內水量：每次出車任務完成回到站內的時候，檢查儲水罐內的水量，讓水罐中的水隨時處於滿罐的狀態，以備不時之需。
2. Return to the factory to check the water quantity in the tank: check the water quantity in the water storage tank every time when you return to the station after the completion of the task, so that the water in the water tank is full at any time, in case of emergency.
3、離廠前檢查混凝土質量：可能會因為原料的不同，每一盤混凝土質量都會有變化。
3. Check the quality of concrete before leaving the factory: the quality of each plate of concrete may change due to different raw materials.
4、減少車輛行駛時間：混凝土運距一般在直徑30千米範圍以內，出車之前規劃好路線以及車輛通行情況。
4. Reduce vehicle travel time: the concrete transportation distance is generally within the range of 30 km in diameter, and the route and vehicle traffic conditions should be planned before driving.
5、減少損失先卸料：如果遇到人為因素或者不可抗因素，導致長時間無法卸料的情況，一旦發現混凝土開始凝結，在報備負攪拌責自動上料攪拌車防止粘罐的方法人之後立刻進行卸料，以防整個罐體報廢。卸料前讓攪拌罐全速運轉一兩分鍾。讓混凝土充分攪拌，必要時可以加一些水，讓混凝土攪拌得更均勻，也方便卸料。卸料不要大意和放料工打好關係。放料時盡量自己看著，免得放料工亂操作放料操作杆，每次罐子正反轉中間位子時盡量停一下，保護減速機，托輪等。與放料工打好關係，卸料時也不要睡的太熟，萬一工人鬧情緒，把你車子放到工地不轉罐子，造成悶罐就麻煩了。
5. To reduce the loss, discharge first: in case of failure to discharge for a long time due to human factors or irresistible factors, once it is found that the concrete begins to set, discharge immediately after reporting the method of automatic feeding mixer with responsibility for mixing to prevent sticking to the tank, so as to prevent the whole tank from being scrapped. Let the mixing tank run at full speed for one or two minutes before discharging. Let the concrete mix fully. If necessary, add some water to make the concrete mix more evenly and discharge easily. Don't be careless in discharging and have a good relationship with the discharger. When discharging, try to watch by yourself, so as to avoid the disorderly operation of the discharging lever by the discharging worker. Every time when the can is in the middle position, try to stop as much as possible to protect the reducer, supporting wheel, etc. Have a good relationship with the discharging worker, and don't sleep too well when discharging. In case the worker is in a mood and puts your car on the construction site without turning the can, it will be troublesome if the can is stuffy.
6、攪拌罐一定要仔細地衝洗幹淨。洗罐子時一定要仔細的衝洗幹淨，並把水反複的正反轉兩次，再放出來，然後一趟時把水箱的水全部放進罐子，再回到站加水清洗罐子。
6. The mixing tank must be washed carefully. When you wash the pot, you must wash it carefully, and put the water back and forth for two times, then put all the water in the tank into the pot, and then go back to the station to add water to clean the pot.
以上是駕駛自動上料攪拌車一定要做的事情，而且細節問題要做好。
The above is driving automatic feeding mixer must do things, and details to do.
以上的精彩內容均有混凝土攪拌車為您提供，更多的精彩內容請查看kaiyun的網站：http://www.skar-bnat.com，kaiyun後續會有更多的精彩內容為您呈現。
All the above wonderful contents are provided by concrete mixer. For more wonderful contents, please check our website: http://www.skar-bnat.com We will have more wonderful content for you in the future.
